top of page
  • _

Renovation Innovation...Bathroom

(There are over 20 pics for this blog, click "More" at the bottom of the last pic to see all the pics and text.)

We were so lucky, if not the luckiest, to been hired by one of the nicest clients ever.  

Our client wanted more space, a shower instead of the tub, taller vanity and toilet.  The toilet/tub area was cramped, however, the vanity area used about 3' of space that could serve a better purpose. 

On this particular remodel we gutted everything and started from scratch all over. We 'scooted' things to the right by moving the toilet about 10". 

As you scroll down you'll see that we removed the vanity, wall mirror, wall, toilet, tub, wall and floor tile, as well as all the wall and ceiling sheetrock.

We then went to work on converting the plumbing from tub to shower (including moving the shower drain to match the new shower) as well as cutting into the subfloor to literally move the toilet. 

After things were ok'd we started with installing all of the sheetrock (taping, pasting, sanding etc). Sheetrock is a process you can't rush. It typically takes three rounds of mud (paste) to have a smooth looking wall. . This means letting the paste dry 24 hours before you can sand and apply more.

Once the joint compound (mud) process is complete we primed the walls for sheetrock proctection (mildew) and adhesive purposes (so the paint sticks/grabs/holds well). 

Right around this time we're all smiles as we're past the halfway mark with the finish work commencing. We used a satin finish paint from Sherwin Williams as a satin finish helps resist moisture. 

Our client opted for tile flooring with a slight decorative look. We used 1/4" backer board on top of the subfloor & thin set prior to installing the tile. The tile was spaced with 1/4" spacers for a nice look when we applied the grout (and sealed afterwards). We found nice small tile pieces that matched well with her 36.5" h cherry vanity. 

Next came assembling and installing the new shower. After the prep work we used a safe adhesive to glue the panels as recommended by the manufacturer. We then started with the framing, panels and polished trim until the shower was erect and secure. 

The porcelain piece was next along with the light fixtures and other accessories. 

Conclusion? To us the real magic occurred when our client put her touches and made the bathroom feel warm all over again. 

2 views0 comments

Recent Posts

See All


bottom of page